3 Series E46 316i (M43TU) SAL
Release nuts (1) and disconnect lines.
Installation:
Tightening Torque, refer to
Technical Data 12 41 4AZ
Both starter mounting bolts are best released:
Release starter mounting bolts from transmission output end with
a long extension and a universal joint.
Installation:
Tightening Torque,
refer to Technical Data 12 41 1AZ
Remove starter (1) from transmission flange. Ensure that the
sealing faces of the fuel lines (2) are not damaged.
Remove starter (1) towards bottom past fuel lines.
Installation:
Check starter pinion for damage.
Check starter crown wheel for damage.
Information on troubleshooting and disassembly of starter,
refer to 12 41 513
RA Removing and installing or replacing starter (M43TU)
BMW AG - TIS
19.01.2013 11:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
