3 Series E46 316i (M43TU) SAL
12 61 280
Removing and installing or replacing oil
pressure switch (M43TU)
Turn off ignition.
Release oil filter cap so that engine oil from oil filter can
flow back into oil pan.
Installation:
Resecure oil filter cap.
Check engine oil level, top up oil if necessary.
Remove alternator,
refer to 12 31 020
Remove power steering pump, hydraulic lines remain connected
however.
Release screws (1) on alternator bearing block.
Grip alternator bearing block (2) firmly and release screw (1),
remove bearing block.
RA Removing and installing or replacing oil pressure switch (M43TU)
BMW AG - TIS
19.01.2013 11:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
