3 Series E46 316i (M43TU) SAL
Release screw (1).
Pull condenser of A/C system towards rear out of mounts.
Tilt condenser to engine, do not damage condenser in the
process.
Note:
Lines of A/C system remain connected to condenser.
Press lines (1/2) in direction of cooling loop and pull black locking
ring towards rear. Keep locking ring pressed and detach lines
(1/2) from cooling loop.
Detach seal (3).
Caution!
Catch and dispose of emerging fluid.
Installation:
Note position of lines. Notch on fast-release coupling must line up
with notch on cooling loop. Fast-release coupling must snap
audibly into place.
Release lock (1). Pull cooling loop of power steering towards rear
out of module carriers.
RA Removing and installing/replacing cooling loop for power steering
BMW AG - TIS
19.01.2013 11:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
