3 Series E46 316i (M43TU) SAL
Installation:
Pay attention to adapter sleeves (1 and 2).
If necessary, withdraw adapter sleeves from transmission housing
and install new adapter sleeves in engine block.
Installation:
The sheet metal flywheel is equipped with three recesses for
the torque converter retaining lugs.
When joining together engine and transmission, the three
retaining lugs on the torque converter must be aligned with
the three recesses in the sheet metal flywheel.
Failure to comply with this requirement leads to secondary
damage on the automatic transmission.
The torque converter or engine is not able to spin and would
cause damage.
Installation:
Bore on driver must point to center of aperture in cover plate.
Installation:
Twist torque converter on transmission until bores on lugs
point to center of bore on flywheel.
Screw special tool 24 2 300 into lug.
RA Removing and installing automatic transmission (A4S 310R)
BMW AG - TIS
19.01.2013 11:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
