3 Series E46 316i (M43TU) SAL
Grip propeller shaft and release nuts.
Tightening torque 26 11 6AZ.
Bend propeller shaft downwards at center mount (1) and detach
from transmission output flange.
Tie propeller shaft at sides to underbody of vehicle.
Grip output flange (1) with special tool 23 0 020 .
Release hexagon nut.
Tightening torque, 24 21 1AZ.
Installation:
Install hexagon nut with screw retaining compound.
Remove spring washer (1).
Installation:
Note installation direction of spring washer (1).
Remove output flange (2).
Installation:
Replace sealing ring in output flange (2).
Withdraw radial seal (1) with special tool 00 5 010 .
RA Removing and installing or replacing transmission extension housing (A4S 200R)
BMW AG - TIS
19.01.2013 11:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
