3 Series E46 316i (M43TU) SAL
Brace cable at hexagon (1) and release nut (2).
Tightening torque, 25 16 1AZ.
Pull cable out of holder.
Note:
Do not turn handle (1) when pulling off as this would shear off
the turning lock in the handle.
Pull off handle (1) with a forceful tug.
Installation:
Attach handle (1) to selector lever. Align handle (1) and press
on until it can be felt snapping into place.
Remove trim (2).
Installation:
Push rubber gaiter (1) downwards until groove (2) is fully
exposed.
Disconnect plug connections 1 and 2.
Remove trim (3) with rubber gaiter.
Installation:
The lines must be correctly clipped into the retaining clips so
as to prevent damage (trapping of lines).
RA Removing and installing / replacing shift tower (Steptronic)
BMW AG - TIS
19.01.2013 12:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
