3 Series E46 316i (M43TU) SAL
If necessary, insert new clamping ring (1) in threaded ring (2).
Force threaded ring (1) onto shaft (2).
Grease longitudinal splines of shaft (2) uniformly.
Grease, refer to BMW Service Operating Fluids.
Observe markings and force rear propeller shaft (3) onto
shaft (2) (markings must be flush).
Screw down threaded ring (1) with propeller shaft (3) until hand-
tight.
RA Replacing grooved ball bearing in center mount of propeller shaft
BMW AG - TIS
19.01.2013 12:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
