3 Series E46 316i (M43TU) SAL
31 11 005
Removing and installing/replacing
reinforcement (cruciform)
Important!
Observe safety instructions for raising the vehicle!
Driving without the reinforcement fitted is not permitted!
Reinforcement must not rest on bracket with rubber mount of
control arm!
Remove splash guard, if necessary.
Release bolts (2).
Release bolts (1); if necessary, remove washers.
Remove reinforcement.
Installation:
If a 66 mm dia. control arm rubber mount is fitted, a
washer (S) must be fitted at each bolt (1) between
reinforcement (3) and engine carrier (4).
Tightening torque 31 10 8AZ
.
Important!
If necessary, bend heat shield away from reinforcement.
Diesel engines:
If necessary, recondition (cut) rear left assembly underside
protection in order to create a gap to reinforcement. If the
required change is not made, the assembly underside
protection will tense up and loosen during driving operation!
RA Removing and installing/replacing reinforcement (cruciform)
BMW AG - TIS
19.01.2013 12:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
