3 Series E46 316i (M43TU) SAL
31 11 506
Lowering/raising front axle carrier
Necessary preliminary tasks:
•
Secure engine in installation position
•
Remove underbody protective plate
•
Remove reinforcement/reinforcement plate
•
Remove lower steering spindle from power steering gear
•
If necessary, disconnect plug connection from ride-height
sensor
•
Remove both brackets for control arm from engine carrier
After installation:
•
Carry out steering angle sensor adjustment
Important!
Pay attention to power steering hoses and lines when
lowering and raising. Hoses/lines must not be
kinked/tensioned/bent!
Support front axle carrier in area (A) with workshop jack.
Release screws (1, 2).
Lower front axle carrier.
Installation:
Check threads for damage; if necessary, repair with Helicoil thread
inserts.
Tighten down first screws (2) and then screws (1).
Tightening torque 31 10 1AZ
.
RA Lowering/raising front axle carrier
BMW AG - TIS
19.01.2013 12:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
