3 Series E46 316i (M43TU) SAL
Installation:
Press clamping disk (1) onto operating lever. Marking (K) must
point to operating lever.
Ensure needle rollers are in correct position.
Mount operating lever with clamping disk (1) - hold pressed
together - on housing.
Square section of clamping disk (1) must snap into elongated
hole of mounting bracket.
Installation:
1.
Spring
2.
Needle roller
Grease contact area (A) (Glissando, refer to BMW Parts Service)
and position needle rollers (2) vertically in operating lever.
Installation:
Fit washer (1) on clamping disk (2).
In this case, wide tongue (1.1) must be aligned to wide link (2.2).
K = Marking for installation direction
Remove cable holder.
RA Disassembling and assembling steering column
BMW AG - TIS
19.01.2013 12:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
