3 Series E46 316i (M43TU) SAL
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
Support rear differential with workshop jack and special tool
33 4 420 .
Important!
Observe gap between special tool 33 4 420 and dust
plates (1).
To avoid grinding noises, make sure the dust plates (1) are
not damaged (e.g. bent).
Unfasten screws.
Release nut and pull out bolt towards middle of vehicle.
Slowly lower workshop jack and remove rear differential towards
rear.
RA Removing and installing/replacing rear differential
BMW AG - TIS
19.01.2013 13:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
