3 Series E46 316i (M43TU) SAL
33 32 000
Removing and installing complete left or right
trailing arm
Special tools required:
•
31 5 220
•
33 2 160
Necessary preliminary tasks:
•
Remove output shaft
•
Remove brake disk
•
Disconnect handbrake Bowden cable from expander lock
•
Remove pulse generator
•
Only on right side: remove brake pad sensor
Important!
Risk of damage
Brake hose must not be exposed to tensile loads.
Release screw and remove bracket with brake hose.
Tightening torque 34 32 3AZ
.
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
RA Removing and installing complete left or right trailing arm
BMW AG - TIS
19.01.2013 13:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
