3 Series E46 316i (M43TU) SAL
Bleeding rear-axle brake circuit
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Close bleeder valve.
Run bleeding routine with DIS with bleeder valve open.
After completing the routine, press brake pedal 5 times down to
floor; clear bubble-free brake fluid must emerge.
Close bleed valve.
Repeat procedure at rear left.
Bleeding front-axle brake circuit
Connect bleeder hose with collecting tray to bleeder valve on front
right brake caliper.
Close bleeder valve.
Run bleeding routine with DIS with bleeder valve open.
After completing the routine, press brake pedal 5 times down to
floor; clear bubble-free brake fluid must emerge.
Close bleed valve.
Repeat procedure at front left.
Switch off brake fluid changer and remove from expansion tank.
Check brake fluid level.
Close expansion tank.
Note:
Take care of rubber gasket (1) in lid.
RA Bleeding brake system with DSC3
BMW AG - TIS
19.01.2013 13:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
