3 Series E46 316i (M43TU) SAL
34 21 320
Removing and installing/replacing both brake
disks
Caution!
If the thickness of the brake disks drops below the minimum
level (MIN TH) , the disks must be replaced.
Always replace brake disks in pairs.
If the brake disks are replaced, you must also fit new brake
linings.
Remove wheels.
If necessary, remove and clean brake linings.
After completing work, adjust handbrake,
refer to 34 10 014 .
Unscrew bolts (1). Remove and suspend brake caliper from
vehicle.
Note:
Brake hose remains connected.
Installation:
Tightening torque,
refer to Technical Data 34 21 3AZ.
Unscrew bolts and take off brake disk.
Installation:
Replace brake disk retaining screw.
Tightening torque,
refer to Technical Data 34 21 1AZ.
RA Removing and installing/replacing both brake disks
BMW AG - TIS
19.01.2013 13:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
