3 Series E46 316i (M43TU) SAL
Pull handbrake bowden cables out of guide tubes on body and out
of wheel carrier.
Release one wheel stud.
Bring wheel into position (tapped hole turned down approx. 20
°
from horizontal).
F = direction of travel
Installation:
Reinstall wheel stud only after handbrake has been adjusted.
Nipple (1) and expander lock (2) are visible through tapped
hole.
Push in core of handbrake cable in direction of expander lock as
far as it will go and grip firmly.
Press nipple (1) downwards through tapped hole with a
screwdriver.
Pull out handbrake bowden cable.
Installation:
Insert handbrake bowden cable in brake carrier/brake guard
plate. Sleeve must be inserted up to stop.
Grip sleeve of handbrake bowden cable.
Push in core until it snaps into place.
RA Removing and installing/replacing both handbrake bowden cables
BMW AG - TIS
19.01.2013 13:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
