3 Series E46 316i (M43TU) SAL
34 51 527
Removing and installing/replacing DSC
hydraulic unit (MK60)
DSC (Dynamic Stability Control)
Note:
Read and comply with General Information.
First read out fault memory of control unit and if necessary print
diagnostic record.
Installation:
On completion, carry out following tasks with the DIS (Diagnosis
and Information System):
·
If control unit is new: Coding
·
If control unit is new: Adjustment of steering angle sensor,
pressure sensors and transversal acceleration sensor
·
Function check, hydraulic unit
Bleed brake system.
Caution!
Do not mix up brake lines, mark prior to removal if necessary.
Seal off connection bores with plugs.
Remove brake master cylinder for DSC (MK60).
Disconnect plug connection (1) to control unit.
Release brake lines (F and R).
(F) from THZ circuit F to hydraulic control unit circuit F (front-axle
circuit)
(R) from THZ circuit R to hydraulic control unit circuit R (rear-axle
circuit)
Installation:
Tightening torque, 34 32 1AZ.
RA Removing and installing/replacing DSC hydraulic unit (MK60)
BMW AG - TIS
19.01.2013 13:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
