3 Series E46 316i (M43TU) SAL
Important!
Only separate the outer sheet metal of the B-column.
Cut through marked cutting line of B-pillar, outside, measurements
"E,F".
Drill off spot welding.
Remove metal cutout, "window".
Note:
Cut cutting lines, B-pillar, outside, as on car.
Mark cutting line in cut-out area of B-pillar in centre.
Measurement (A) = 390 mm from upper hinge fixture.
Important!
Only cut through marked sheet metal of B-pillar.
Do not cut through "extended reinforcement plate" of B-pillar.
Drill off "extended reinforcement plate", B-pillar (1), from spare
part so that cut B-pillar can be removed with "extended
reinforcement plate", B-pillar (1).
A = measurement of extended reinforcement plate which is
390 mm from upper hinge fixture above cutting line of B-pillar.
Determine and mark cutting line for cover for front side member:
Measurement (A) = 150 mm.
1 = 1st bore for finishing strip, entrance
1 = 2nd bore for finishing strip, entrance
RA Replacing cover for side member, left or right (partial replacement, B-pillar be
BMW AG - TIS
19.01.2013 14:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
