3 Series E46 316i (M43TU) SAL
Determine and mark cutting line for cover for rear side member:
Measurement (A) = 50 mm from centre of bore for finishing strip,
entrance (1) with dia. 5.5 mm.
Measurement (B) = 165 mm from centre of bore for panel for
cover on side member (2), dia. 9.2 mm.
Cut through marked cutting line.
Make reinforcement plates for cover for side member for
connection point
door pillar (A-pillar) and
C-pillar
from remaining metal sheet.
Width of reinforcements: approx. 60 mm.
Drill holes for plug welding reinforcement plates, connection point
door pillar (A-pillar) and C-pillar in body and cover for side
member spare part.
Clean connection points at door pillar (A-pillar) and C-pillar on
body and cover for side member spare part and coat with zinc
dust paint.
RA Replacing cover for side member, left or right (partial replacement, B-pillar be
BMW AG - TIS
19.01.2013 14:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
