3 Series E46 316i (M43TU) SAL
41 62 014
Adjusting trunk lid to fit
Note:
Engine hood was fitted and bolted in an unfinished body
shell.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
The rear lid is adjusted to fit with built-in gas pressure
dampers and a built-in rear lid seal.
If turning adjustment screws or subsequent machining of
adjustment screws exposes surfaces which do not match
the car color, touch up these surfaces in the appropriate
color.
Protect bright surfaces against rust.
-
Preliminary work:
If necessary, press ejectors into detent buffers and turn slightly to
left in this position with a Phillips screwdriver.
This locks the ejectors in the detent buffers.
Unscrew detent buffers from left and right sides of trunk lid.
RA Adjusting trunk lid to fit
BMW AG - TIS
19.01.2013 14:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
