3 Series E46 316i (M43TU) SAL
51 16 210
Removing and installing / replacing finisher
for preselector lever
Note:
Do not wrench knob when removing as this will cause the
anti-wrench element in the knob to be shorn off.
Tug firmly to remove knob.
Installation:
Attach knob to selector lever, align and press on until it snaps
audibly into place.
Installation:
Push rubber gaiter (1) down until groove (2) is fully exposed.
Installation:
Pull rubber gaiter (2) of trim (1) down and fit onto selector
lever (4).
Attach cable plugs (3) and (5) to trim (1) in center console.
Remove trim (1) with rubber gaiter from center console.
RA Removing and installing / replacing finisher for preselector lever
BMW AG - TIS
19.01.2013 14:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
