3 Series E46 316i (M43TU) SAL
63 13 150
Removing and installing/replacing complete
front left or right turn signal lamp
Up to 09/2001:
Open hood.
Press down retainer (1) through bore in side panel and slide turn
signal lamp towards front.
Installation:
Make sure bonded rubber seal (1) is correctly seated on trim (2).
From 09/2001:
Open hood.
Loosen screw (1).
Installation:
Observe tightening torque, 63 13 2AZ
.
Note:
Secure front turn signal lamp (2) against falling out.
Slide out front turn signal lamp (2) in direct of arrow.
RA Removing and installing/replacing complete front left or right turn signal lamp
BMW AG - TIS
19.01.2013 16:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
