3 Series E46 316i (M43TU) SAL
Installation:
Make sure nut (1) is correctly seated on headlight housing (2).
If necessary, when screwing front turn signal lamp into place,
secure nut (1) with screwdriver (3) against turning.
Installation:
When sliding in front turn signal lamp (1), make sure guides (2)
are correctly seated in headlight mounts (3).
Make sure bonded seal is correctly seated under front turn signal
lamp (1).
All:
Disconnect plug connection (1).
Note:
Turn signal lamp, front left:
To release, turn bulb holder (2) clockwise.
Turn signal lamp, front right:
To release, turn bulb holder (2) counterclockwise.
Turn bulb holder (2) and remove turn signal lamp (3).
Installation:
Make sure seal is correctly seated between bulb holder (2) and
turn signal lamp (3).
RA Removing and installing/replacing complete front left or right turn signal lamp
BMW AG - TIS
19.01.2013 16:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
