3 Series E46 316i (M43TU) SAL
Note:
Do not exert any tension on cable when removing passenger
airbag module (1).
Raise passenger airbag module (1) and move to one side:
- Open lock by pressing on tab (2),
- Disconnect plug connection (3),
refer also to 72 12 ... Unlocking/locking airbag plug connections
- Remove passenger airbag module (1).
Caution!
The passenger airbag module matching the car must always
be fitted!
Under no circumstances may a two-stage passenger airbag
module be fitted if installation of a single-stage passenger
airbag module is specified!
If the EPC (Electronic Parts Catalog) specifies installation of
an adapter cable, this must be fitted in all cases!
Difference between single- and two-stage passenger airbag
modules on 6-pin plug of passenger airbag module:
Supply lead for single-stage passenger airbag module, only
one lead in plug of passenger airbag module!
Supply lead for two-stage passenger airbag module, two
leads in plug of passenger airbag module!
Installation:
When replacing passenger airbag module, after appropriate entry
of vehicle identification number in EPC (Electronic Parts Catalog),
install specified passenger airbag module.
Difference between single- and two-stage passenger airbag
modules on 6-pin plug of passenger airbag module:
1 = Supply lead for single-stage passenger airbag module, only
one lead in plug of passenger airbag module!
2,3 = Supply lead for two-stage passenger airbag module, two
leads in plug of passenger airbag module!
Remove retaining tube (1) from stay bolt (2) and remove complete
cover (3).
RA Removing and installing/replacing airbag module on passenger side
BMW AG - TIS
19.01.2013 17:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
