3 Series E46 316i (N42) SAL
Insert special tool 11 9 340 in cylinder head and bring adjusting
screw by hand on clamping rail into contact but do not pretension
timing chain yet.
Note:
Replace screws of inlet and exhaust adjustment unit.
Install new screws of inlet and exhaust adjustment unit and tighten
without play.
Fit special tool 11 9 350 as illustrated.
Align locating bores of sensor gears to alignment pins on special
tool 11 9 350 .
Secure sensor gears with special tool 11 9 350 .
Screw special tool 11 9 350 to cylinder head.
RA Adjusting camshaft timing (N42 / N46)
BMW AG - TIS
20.01.2013 18:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
