3 Series E46 320d (M47) SAL
Installation:
Clean sealing face and replace seal.
Check adapter sleeves (1) for timing case cover at bottom for
damage and correct installation position.
Installation:
Center oil pump to crankshaft with special tool kit 11 4 200
consisting of special tools 11 4 201 / 202 and 203:
Fit oil pump and align to crankshaft with special
tool 11 4 201 and 11 4 202. Insert special
tool 11 4 203 by hand as far as it will go, then insert and
tighten down screws for oil pump.
If necessary, dismantle oil pump and reassemble.
Note:
Intake neck is secured to oil pump with self-tapping screws.
For this reason, there is no thread on new pump housings.
Thread can be shaped using existing screws.
Unfasten screws and lift off cover.
Note:
Screw (1) with M7 thread.
Remaining three screws with M6 thread.
Installation:
Tighten down all four screws to 9 Nm.
RA Installing and removing or replacing oil pump (M47)
BMW AG - TIS
12.02.2013 13:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
