3 Series E46 320d (M47) SAL
Disconnect plug connection (1) at speed sensor.
Release screw (2) and remove speed sensor together with
retainer.
Release screw and detach speed sensor from retainer.
Mount special tool 13 6 040 on holder.
Mount holder on engine block and push forward as far as stop.
Tighten holder.
Caution!
Retainer may no longer be detached from engine block.
Note:
Special tool 13 6 040 must rest against sensor pin (1) of
flywheel.
The required clearance between the sensor pin on the
flywheel and the speed sensor is thus adjusted.
Release special tool 13 6 040 from retainer and remove.
Mount speed sensor and tighten down.
Add final details to vehicle.
Switch on ignition. Check function.
Read error memory on DDE control unit, check faults in memory,
rectify faults then clear the error memory.
RA Replacing speed sensor (pulse generator) (M47)
BMW AG - TIS
12.02.2013 13:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -