3 Series E46 320d (M47) SAL
Attach special tool 11 8 022 to left and right control arms.
Lower transmission until cylinder head touches bulkhead.
Caution!
Position special tool so that engine oil sump is securely
resting on special tool.
Tighten down knurled screws until special tool rests against
engine oil sump.
Support transmission with a workshop hoist.
Release screws.
Tightening torque, 23 00 1AZ.
Caution!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Pay attention to guide sleeves (1 ... 2), replace if necessary.
Ensure correct position of cover plate.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
RA Removing and installing transmission (S5D 320Z, M47)
BMW AG - TIS
12.02.2013 14:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
