3 Series E46 320d (M47) TOUR
Unfasten engine section of wiring harness and place to one side
with cable duct.
This work is described in Replacing engine section of wiring
harness,
refer to 12 51 001.
Remove alternator drive belt,
refer to 11 28 010.
Disconnect fuel feed and return lines from fuel filter. This work is
described in Replacing fuel filter unit,
refer to 13 32 061.
Remove vane pump from timing case cover (lines remain
connected),
refer to 32 41 060.
Pull lock and detach water hoses from coolant thermostat and
EGR cooler.
Installation:
Refer to general instructions for work on cooling system.
Detach water hoses from heater.
Release lower water hose (1) at double pipe on rear cylinder
head.
RA Removing and installing engine (M47)
BMW AG - TIS
12.02.2013 12:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
