3 Series E46 320d (M47) TOUR
13 32 040
Removing and installing/replacing fuel cooler
(M47)
Turn off ignition.
Caution!
When working on the oil, coolant or fuel circuit, you must
protect the alternator against contamination.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an alternator
malfunction.
Caution!
Catch escaping fuel.
Release screws (1) on air duct.
Tightening torque,
refer to Technical Data 13 32 3AZ.
Release hose clamps (2 and 3) on fuel feed and fuel return and
disconnect hoses.
Installation:
Always replace hose clamps.
Release screws (4) (3 screws) and remove fuel cooler.
Drain and dispose of fuel from fuel cooler.
Installation:
To vent fuel filter:
Turn on ignition and leave on for approx. 1 minute. In this
period of time, the fuel pre-supply pump is activated and the
fuel cooler is filled with fuel and vented.
RA Removing and installing/replacing fuel cooler (M47)
BMW AG - TIS
12.02.2013 13:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
