3 Series E46 325i (M54) TOUR
11 12 100
Removing and installing/replacing cylinder
head (M52TU / M54 / M56)
Special tools required:
•
00 0 200
•
00 9 120
Remove both exhaust manifolds.
Note:
After removing exhaust manifolds:
Reinstall engine support arm with engine mount and remove
special tool 00 0 200 .
Remove intake filter housing with air-mass flow sensor.
Remove cylinder head cover.
Remove all spark plugs.
Remove intake air manifold.
Remove coolant drain plug in engine block. Drain and dispose of
coolant.
Installation:
Replace sealing ring on drain plug.
Tightening torque, 11 11 5AZ
.
Vent cooling system and check for leaks.
Remove coolant thermostat housing.
RA Removing and installing/replacing cylinder head (M52TU / M54 / M56)
BMW AG - TIS
13.02.2013 23:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -