3 Series E46 325i (M54) TOUR
E53 only:
Remove water reservoir for windshield washer system.
Remove cable (1) with profile seal from partition wall (3).
Unclip cable (2) from partition wall (3).
Release screw connection of partition wall (3) with body.
Remove partition wall (3).
Pull profile seal (1) out of electronics box.
Release locks (2).
Remove strip (3).
Pull out profile seal (4).
Installation:
To prevent leaks, you must install profile seals (1 and 4) correctly.
E46 and Z3 only:
Note:
Shown on the E46. The same procedure applies to the Z3.
Pull off sealing strip (1).
Remove cable (3) together with profile seal (2) from partition
wall towards top.
Installation:
To prevent leaks, you must install profile seal (2) correctly.
E39 only:
Release locks (1).
Remove cable (3) together with profile seal (2) from partition
wall towards top.
Installation:
To prevent leaks, you must install profile seal (2) correctly.
RA Replacing wiring harness section for ignition coils (M54)
BMW AG - TIS
13.02.2013 23:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -