3 Series E46 330d (M57) TOUR
Release screws on oil-water heat exchanger (1).
Remove oil-water heat exchanger (1) from oil-filter housing (2).
Replace profile seals (1) on oil filter housing (2).
Installation:
Clean all sealing surfaces.
Caution!
In order to avoid damage to the engine caused by coolant
admixture in the engine oil, it is absolutely essential after
completing work to drain and change the engine oil at the
engine oil drain plug.
Failure to comply with this procedure may result in serious
engine damage.
Add final details to vehicle.
Start engine and run at idle speed until oil indicator lamp goes out.
Switch off engine, wait 10 minutes and then check engine oil level.
Top up engine oil if necessary.
RA Removing and installing / sealing or replacing complete oil-filter housing (M57)
BMW AG - TIS
15.02.2013 09:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -