3 Series E46 330xd (M57) TOUR
Hold engine hood.
Unhook damper on engine hood.
Slide special tool 51 2 160 over damper.
Open hood fully and reattach dampers to hood with special tool
51 2 160.
To avoid damaging plug (1) when lifting engine out, disconnect
plug (1) from pressure sensor (2).
Detach sealing strip (1).
Pull out profile seal (2).
Release screw (3).
Pull out profile seals (4 and 5).
Installation:
To prevent leaks, you must install profile seals correctly.
Release screws (1).
Remove cover from electronics box.
Installation:
Tightening torque,
refer to Technical Data 12 90 4AZ.
RA Removing and installing engine (M57)
BMW AG - TIS
15.02.2013 20:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
