3 Series E46 330xd (M57) TOUR
Determine and mark out cutting line for D-pillar.
Distance (A) = 90 mm from bore for retaining clip, trim strip (1).
Distance (B) = 90 mm from bore for retaining clip, trim strip (1).
Determine and mark cutting line for cover for rear side member:
Measurement (A) = 130 mm from center of bore for panel for
cover on side member (1) with dia. 9.5 mm.
Measurement (B) = 70 mm from center of bore for panel for cover
on side member (2) with dia. 9.5 mm.
3 = Bore in cover for side member with dia. 16 mm
Determine and mark cutting line for cover for rear side member:
Measurement (A) = 10 mm from center of bore for finishing strip,
entrance (1) with dia. 5.5 mm.
2 = Bore in cover for side member with dia. 16 mm
3 = Bore for panel for cover on side member with dia. 9.5 mm.
Drill out welding spots for reinforcement of cover for side member
in door aperture.
RA Replacing rear left side wall (part replacement C- and D-pillar, top) (touring)
BMW AG - TIS
16.02.2013 04:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
