3 Series E46 330xi (M54) SAL
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Remove any grease and lining abrasion from taper splines of
clutch plate by mechanical means (with a cloth).
Installation:
Greasing specification.
-
Remove and clean release bearing and release lever.
-
Push on grease scraper ring 21 2 221 as far as it will go.
-
Grease splines (1) of input shaft with a brush. Refer to BMW
Service Operating Fluids.
-
Detach grease scraper ring.
RA Removing and installing transmission (GS6-37BZ, AWD)
BMW AG - TIS
16.02.2013 08:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -