3 Series E46 M3 (S54) COUPE
Release screws on actuator.
Tightening torque 23 41 1AZ
.
Release screw (1).
Installation:
Replace screw (1).
Release screw (2) on actuator.
Tightening torque, 23 41 4AZ
.
Remove actuator.
Important!
Hydraulic lines and connectors remain connected.
Unfasten screws.
Tightening torque 23 00 1AZ
.
Important!
Do not allow transmission to hang on transmission input shaft
when removing and installing, as the clutch disc will be
deformed.
Pull out transmission as far as possible towards rear, turn approx.
10
°
in counterclockwise direction and remove.
Installation:
Pay attention to correction position of dowel sleeves.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
RA Removing and installing transmission (S6S 420G SMG)
BMW AG - TIS
16.02.2013 15:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
