3 Series E90 318i (N46) SAL
12 13 511
Replacing ignition coils (N42, N40, N46, N45)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Remove ignition coil cover
Illustrations show N42:
Unlock fastener (1) of ignition coil.
Pull off plug (1).
Pull out ignition coil (2).
This procedure is applicable to all ignition coils.
Installation:
The casting on the cylinder head cover or the cylinder head (2)
must be inserted in the opening on the underside (1) of the
rubber seal.
RA Replacing ignition coils (N42, N40, N46, N45)
BMW AG - TIS
21.01.2013 20:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -