3 Series E90 325xi (N52) SAL
Fit special tool 21 2 170 and tighten down at knurled screw (1).
Screw in spindle (1) until diaphragm spring (2) is tensioned up to
stop.
Important!
Handle clutch disk carefully, do not touch surfaces of friction
pads.
Install clutch plate in correct position.
Note designation for "engine side" / "transmission side".
Installation:
N52
Screws must be replaced.
Jointing torque and angle of rotation must be observed without
fail.
Centre clutch plate (1) with special tool.
Special tool
Transmission
21 2 141
RA Removing and installing or replacing clutch (SAC 228)
BMW AG - TIS
11.02.2013 12:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -