3 Series E90 M3 (S65) SAL
13 62 540
Removing and installing/replacing throttle
valve actuating motor (S65)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit; if necessary,
work through test schedules
•
Switch off ignition
•
Remove intake air manifold
•
Partially remove engine wiring harness
Note:
Illustration shows and description refers to the left throttle valve
servomotor. The procedure is identical for the right intake duct.
Remove thrust rod (1).
Release screws.
Remove throttle valve servomotor (2).
Important!
After performing work on the throttle valve system (throttle
valve assembly, servomotor, Hall sensor), it is absolutely
essential to carry out a throttle valve actuator system test with
the BMW diagnosis system!
Function selection:
-
Complete vehicle
-
Drive
-
Engine electronics
-
Air supply
-
Throttle valves
-
Throttle valve actuator
RA Removing and installing/replacing throttle valve actuating motor (S65)
BMW AG - TIS
22.02.2013 11:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
