3 Series E92 316i (N43) COUPE
Lubricate all bearing caps with oil according to identification (E1
to E4) and fit in correct position.
Tighten down all nuts of bearing shells (E1 to E4) uniformly in
order (1 to 8) by a half turn.
Installation:
The holders for the oil line must be mounted (see arrows) on
bearing caps (E1 and E4).
Tightening torque: 11 31 1AZ
Press upper chain guide (1) in direction of arrow.
Fit bearing shell (2).
Tighten down nuts (2 to 5).
Tightening torque: 11 31 1AZ
.
Important!
Screws can fall into the timing case (risk of damage!).
Insert screws (1) of upper chain guide.
Tightening torque: 11 31 4AZ
.
RA Removing and installing/replacing inlet camshaft (N43)
BMW AG - TIS
20.01.2013 10:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
