3 Series E92 316i (N43) COUPE
Unlock lug (1) in direction of arrow, slide plug (2) out of DME
plug (3).
Unlock plug (1) and remove.
Withdraw profile seal from electronics box.
Installation:
To ensure leak-tightness, make sure profile seal is correctly
seated in electronics box.
Unlock carrier plate (1) and raise in direction of arrow.
Work step
Note:
Unlock plug on DME control unit and disconnect.
Unclip fuse.
Unlock plug connection in rear section of electronics box and disconnect.
Withdraw profile seal from electronics box.
Installation:
To ensure leak-tightness, make sure
profile seal is correctly seated in
electronics box.
RA Replacing engine wiring harness (N43)
BMW AG - TIS
20.01.2013 10:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
