3 Series E92 335i (N54) COUPE
Release bearing cap screw connections from outside inwards.
Lift out lower and upper bearing banks (1) with camshaft.
Note:
Illustration shows N52.
Remove upper bearing shell.
Remove intake camshaft (1) marked with (E).
Important!
Both camshafts have different identifications.
Mixing up the two camshafts will result in engine damage.
A
Exhaust camshaft.
E
Intake camshaft
Check plain compression rings (1) for damage and replace if
necessary.
Plain compression rings (1) are engaged at joint.
Press plain compression rings (1) apart upwards and downwards
and removed towards front.
Important!
Plain compression rings (1) can easily break.
RA Removing and installing or replacing intake camshaft (N54)
BMW AG - TIS
18.02.2013 17:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -