Removing And Installing Intake Camshaft on 3 Series E92 335i (N54) - Page 342
Important!
Removal on engine:
Set engine to ignition TDC at cylinder No. 1.
Removed cylinder head:
When using special tool 11 9 000 , it will be necessary to
remove the aluminium profile insert.
Installing camshaft bearing bank:
Pre-install special tool 11 8 551 on cylinders 2 and 3.
Insert special tool 11 8 552 in screw connection of cylinder head
cover.
Special tool 11 8 551 is marked with letters E and A.
E = intake side.
A = exhaust side.
Press down roller cam followers on 3rd cylinder with spindle
nut (2) of special tool 11 8 551 .
Installation:
Before installing intake camshaft, make sure roller cam follower is
correctly seated on HVCA element and valve.
Installation:
Pre-install bearing strip of intake camshaft.
Lubricate all bearing points in lower bearing strip with engine oil.
Installation:
Lay intake camshaft (1) in bearing strip.
RA Removing and installing or replacing intake camshaft (N54)
BMW AG - TIS
18.02.2013 17:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -