5 Series E34 525td (M51) TOUR
11 14 151
Replacing crankshaft radial seal (M41 / M51)
(Transmission side)
Remove transmission.
Drain engine oil.
Remove flywheel.
Unfasten oil pan screws on transmission end.
Loosen oil pan.
Unfasten screw on rear end cover.
Carefully unfasten oil pan seal from end cover and remove end
cover.
Note:
After removing end cover, check oil sump gasket for damage.
If necessary, remove oil sump and replace oil sump gasket.
Note:
As from 4/98, a new type of radial seal is used in the Series
and as a replacement. This radial seal may only be supported
with a "support bushing".
If the radial seal is supported without the support bushing (1)
for more than six months, operational reliability will no longer
be assured and the radial seal must not be used any further.
RA Replacing crankshaft radial seal (M41 / M51)
BMW AG - TIS
23.01.2013 06:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -