5 Series E34 525td (M51) TOUR
Tightening specifications for main bearing:
1.
Tighten all screws on main bearing cover with jointing torque.
2.
Unfasten screws on main bearing cover 6.
3.
Strike back and front of crankshaft with plastic hammer to
center thrust bearing (do not damage crankshaft).
4.
Tighten screws of main bearing cover 6 with jointing torque.
5.
Tighten all screws of main bearing cover with special
tool 11 2 110 or special tool 00 9 120 with torsion
angle.
Tightening torque,
refer to Technical Data 11 11 1AZ
Checking end float,
refer to Technical Data
If necessary, check guide bearing shells, crankshaft and engine
block.
RA Replacing main crankshaft bearing shell (M51)
BMW AG - TIS
23.01.2013 06:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -