5 Series E34 525td (M51) TOUR
13 51 001
Removing and installing/replacing injection
pump (M51)
Connect MoDiC or DIS to diagnosis jack. Select diagnostic
program of DDE control module, select Special functions or
Test module, follow instructions on how to proceed. Read
fault memory of DDE control module.
Switch off ignition.
Follow instructions for disconnecting and connecting battery,
refer to General Information MG12.
Remove ground wire from battery.
Unscrew and remove splash guard.
Remove fan and fan cowl,
refer to 11 52 020.
Remove intake air manifold,
refer to 11 61 050.
Installation:
With aluminum suction units: Replace seals.
With plastic suction units: check seals in suction unit and
replace, if necessary.
Replace leakage oil hoses after disassembly.
Remove hose for leakage oil (1).
Remove return line (2). Hollow union bolt (3) is matched with the
injection pump.
Remove fuel line (4).
Installation:
Replace leakage oil hoses after disassembly.
RA Removing and installing/replacing injection pump (M51)
BMW AG - TIS
23.01.2013 06:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
