5 Series E34 525td (M51) TOUR
Installation:
Depending on the injection pump bearing block, it is essential
to install an intermediate ring to support the injection pump.
Remove intermediate ring (1) if the injection pump centering
diameter (2) is 68 mm.
Only pump replacement:
Installation:
Convert mounting and securing components.
Move injection pump shaft to installation position with special tool
13 5 062.
The rotary lever must be positioned vertically in front of the
protruding cam.
Make sure that the Woodruff key does not fall out while installing
the injection pump.
RA Removing and installing/replacing injection pump (M51)
BMW AG - TIS
23.01.2013 06:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -