5 Series E34 525td (M51) TOUR
If necessary, lift out retaining plate (1).
Installation:
Do not fit retaining plate.
Brace output flange with special tool 23 0 020 .
Release collar nut with special tool 23 1 210 .
Installation:
Install collar nut with screw retaining compound; for
compound,
refer to BMW Parts Service.
Tightening torque, 23 21 1AZ.
Detach output flange with special tool 33 1 150 from output
shaft.
Installation:
For transmissions from year of manufacture 01/99: heat
output flange to approx. 80
°
C, e.g. with a hot air blower.
Slide output flange onto the output shaft.
Remove radial seal with special tool 00 5 010 .
RA Replacing radial seal for output flange (S5D 200G/ 250G)
BMW AG - TIS
23.01.2013 07:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
