5 Series E34 525td (M51) TOUR
Insert magnets (4) in rear housing section.
Attach roller bearing (5) with small diameter facing outwards.
Note:
Coat needles with grease and press them in to avoid canting
of the needles when mounting the front case section.
Clean housing sealing surfaces and coat with sealing compound,
refer to BMW Parts Service.
Hold the 5th/reverse gear shift arm in horizontal position with a
piece of string to make installation easier.
Attach front housing section up to centering pin (1).
Insert 2 auxiliary screws M8 x 75 mm for centering housing
opposing on left and right in rear housing section.
Install special tool 23 2 293 in front housing section.
RA Removing and installing complete drive and output shafts (S5D 260Z / 310Z / 320Z
BMW AG - TIS
23.01.2013 07:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -
