5 Series E34 525td (M51) TOUR
Attach special tool 23 2 290 to drive shaft.
Attach support shells (1) to drive shaft with conical side facing
inwards.
Unscrewing the spindle presses the front case section on to the
input shaft.
Press on front housing section only to such an extent that auxiliary
cord can be removed again after installation of right bearing pin.
Center 5th/reverse gear shift arm (1) with bore and install right
bearing pin (2). Do not tighten down.
Note:
Replace bearing pin (2). Clean thread in housing.
Remove auxiliary cord.
Press on front housing section as far as it will go.
Remove special tool 23 2 290 completely.
Remove auxiliary screws from housing.
Clean front housing section to rear section.
Tightening torque, 23 11 1AZ.
Remove special tool 23 2 270 from selector shaft.
Center 5th/reverse gear shift arm (1) with bore and screw in left
bearing pin (2) by hand.
Screw in left bearing pin (2) by hand.
Tighten down bearing pins (2) on left and right.
Tightening torque, 23 31 1AZ.
Note:
Replace bearing pin (2). Clean thread in housing.
RA Removing and installing complete drive and output shafts (S5D 260Z / 310Z / 320Z
BMW AG - TIS
23.01.2013 07:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -
